LPC2148 ADC PDF

Jul 20, An in-depth tutorial for learning lpc adc programming. This post is about ADC in LPC ARM7 Microcontroller. Interfacing analog sensors using ADC is simple and efficient technique to read data from sensor. An ADC converter is a device that converts a continuous physical quantity, c program of ADC of ARM7 (LPC), protious simulation.

Author: Gajora Dogrel
Country: Nigeria
Language: English (Spanish)
Genre: Sex
Published (Last): 6 May 2008
Pages: 402
PDF File Size: 6.73 Mb
ePub File Size: 12.79 Mb
ISBN: 952-6-57128-994-9
Downloads: 25847
Price: Free* [*Free Regsitration Required]
Uploader: Kalkree

It does not mean what you think it does. But the major wdc I’m facing now is that even the output value for a constant analog supply say 3v is not coming steadily. So we use while loop to constantly check if conversion is done on the 31th bit of data register.

ADC (Analog to Digital Converter) in ARM LPC | ARM7-LPC

Almost anything can result in bad ADC readings, so you really have to check lpc148 everything is ok. You may get a 2. I am working on it, soon will be posted. Comments Log in or register to post Comment.

Now the problems are — 1: Not just the reference supply but the board supply. If you have any question then please feel free to drop comment. For a Bit ADC result the value stored varies from 0 to It works fine if you have very little noise on the board.

TOP Related Posts  ENCIKLOPEDIJA POLITICKE KULTURE PDF

Your details are much helpful indeed. I dont know why this is happening 2: Having a voltage reference with a lower voltage than what you want to adcc would mean that you need to add a voltage divider to make sure that the input voltage is within range.

LPC2148 – ADC Tutorial

Following lines are used to display input analog voltage 0 to xdc. Have you also checked it with an oscilloscope and seen if it – besides changing value with the input voltage – also has noise? The first six or maybe eight bits of the ADC output are relatively easy to get to produce reasonable values.

ADC operating frequency is 4. In electronics world there are many varieties of analog sensors in lc2148 market that are used to measure temperature, speed, displacement, pressure etc.

Read-Only Author kaushik ghosh Posted 9-Nov Wouldn’t you say that a debugger would be a good too to use, to figure out where it stalls?

We are lp2c148 waiting for any answer to this: The potentiometer is used to supply various analog voltage to the pin When the register is read and ADCR written. As we all know many interface methods have been developed over years to solve complex problem of balancing need of features, cost, size, power consumption, reliability etc.

TOP Related Posts  LEUCEMIA PROLINFOCITICA PDF

ADC activation in LPC

It must not exceed 3. Is the ADC powered?

AD0 is channel 0 and AD1 is channel 1. It increases when I increase the supply voltage to the board. Or more explicitly which board. If I reset the board or switch on the board after switching it off then the right value of 3V is showing up.

Next Introduction of C. We can adjust the contrast by turning the knob.

LPC 2148 ADC

The external signals are easy to look at. Now what to do. LPC ADC kaushik ghosh yeah u r rite what i mean to say is that in my development board the Vref pin is internally connected with Vcc.